User Tools

Site Tools


videoconf:tandberg

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
videoconf:tandberg [2018/02/07 08:54]
deul
videoconf:tandberg [2018/02/07 09:25] (current)
deul
Line 9: Line 9:
 {{ :​videoconf:​tandberg_vc_remote.jpg?​150|}} The Tandberg Edge 85MXP system consists out of a controller box, a movable camera and a table microphone pad. It is connected to the CTOUCH screen through its HDMI connector (The CTOUCH can also be used as a presentation screen without using the Video Conferencing unit, by selecting the PC input). {{ :​videoconf:​tandberg_vc_remote.jpg?​150|}} The Tandberg Edge 85MXP system consists out of a controller box, a movable camera and a table microphone pad. It is connected to the CTOUCH screen through its HDMI connector (The CTOUCH can also be used as a presentation screen without using the Video Conferencing unit, by selecting the PC input).
  
 +===Start===
 {{:​videoconf:​tandberg_screen_remote.jpg?​150 |}}Before you can see anything, you need to activate the screen. Press the On button on the remote to switch the screen on. Then make sure you have selected the HDMI2 input to allow the Video Conferencing unit display. To do this, press the '​Input'​ button on the Screen remote and select the HDMI2 input. Hit '​OK'​ to switch to the newly selected input channel. {{:​videoconf:​tandberg_screen_remote.jpg?​150 |}}Before you can see anything, you need to activate the screen. Press the On button on the remote to switch the screen on. Then make sure you have selected the HDMI2 input to allow the Video Conferencing unit display. To do this, press the '​Input'​ button on the Screen remote and select the HDMI2 input. Hit '​OK'​ to switch to the newly selected input channel.
  
 To enable the Video Conferencing unit pick up the remote and wiggle it or hit the '​OK'​ button. You will see the camera moving out of its rest position towards the preset active position. At the same time the screen display should show you the main Video Conferencing page. To enable the Video Conferencing unit pick up the remote and wiggle it or hit the '​OK'​ button. You will see the camera moving out of its rest position towards the preset active position. At the same time the screen display should show you the main Video Conferencing page.
  
 +===Call===
 {{:​videoconf:​tandberg-welcome.jpg?​400 |}}You can now type in a remote IP number to connect to another Video Conferencing unit (the . in the IP number can be replaced with a *). After typing the IP address, you press the green pickup button on the Tandberg remote to establish the connection. {{:​videoconf:​tandberg-welcome.jpg?​400 |}}You can now type in a remote IP number to connect to another Video Conferencing unit (the . in the IP number can be replaced with a *). After typing the IP address, you press the green pickup button on the Tandberg remote to establish the connection.
  
videoconf/tandberg.txt ยท Last modified: 2018/02/07 09:25 by deul