This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
videoconf:tandberg [2018/02/07 08:22] – [Tandberg Edge 85MXP, Oort 531] deul | videoconf:tandberg [2018/02/07 08:52] – deul | ||
---|---|---|---|
Line 7: | Line 7: | ||
====How to operate==== | ====How to operate==== | ||
- | {{ :videoconf:edge_front.jpg?300|}} The Tandberg Edge 85MXP system consists out of a controller box, a movable camera and a table microphone pad. It is connected to the CTOUCH screen through its HDMI connector (The CTOUCH can also be used as a presentation screen without using the Video Conferencing unit, by selecting the PC input). | + | {{ :videoconf:tandberg_vc_remote.jpg?150|}} The Tandberg Edge 85MXP system consists out of a controller box, a movable camera and a table microphone pad. It is connected to the CTOUCH screen through its HDMI connector (The CTOUCH can also be used as a presentation screen without using the Video Conferencing unit, by selecting the PC input). |
- | To enable the Video Conferencing unit pick up the remote and wiggle it. {{: | + | {{: |
- | You can now type in a remote IP number to connect to another Video Conferencing unit (the . in the IP number can be replaced with a *, so our | + | To enable the Video Conferencing unit pick up the remote and wiggle it. You will see the camera moving out of its rest position towards the preset active position. At the same time the CTOUCH display should show you the main Video Conferencing page. |
+ | |||
+ | {{: | ||
+ | |||
+ | While in connected state you can contraol what you see on the display by presing the 'Self view' button on the remote and then toggle through the layout option using the ' | ||
{{ : | {{ : |