This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
videoconf:tandberg [2018/02/06 08:58] – deul | videoconf:tandberg [2018/02/07 08:52] – deul | ||
---|---|---|---|
Line 1: | Line 1: | ||
======Tandberg Edge 85MXP, Oort 531====== | ======Tandberg Edge 85MXP, Oort 531====== | ||
- | This is the oldest Video conferencing unit we have in house. It is an endpoint Video Conferencing unit so you can either setup a point-to-point connection from this unit to another Video Conferencing unit, or you can call into a Video Conferencing meeting and participate as one of the endpoints in that meeting. | + | This is the oldest Video conferencing unit we have in house. It is an endpoint Video Conferencing unit so you can either setup a point-to-point connection from this unit to another Video Conferencing unit, become the receiving other edge point in a point-to-point connection, or you can call into a Video Conferencing meeting and participate as one of the endpoints in that meeting. |
====Specifics==== | ====Specifics==== | ||
- | {{:videoconf: | + | IP: 132.229.214.150\\ |
+ | Protocol: H323\\ | ||
- | {{ : | + | ====How to operate==== |
+ | {{ : | ||
+ | |||
+ | {{: | ||
+ | |||
+ | To enable the Video Conferencing unit pick up the remote and wiggle it. You will see the camera moving out of its rest position towards the preset active position. At the same time the CTOUCH display should show you the main Video Conferencing page. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | While in connected state you can contraol what you see on the display by presing the 'Self view' button on the remote and then toggle through the layout option using the ' | ||
+ | |||
+ | {{ : |