This is an old revision of the document!
Table of Contents
Cisco SX20, HL 1104
This is the newest Video conferencing unit we have in house. It is an endpoint Video Conferencing unit so you can either setup a point-to-point connection from this unit to another Video Conferencing unit, become the receiving other edge point in a point-to-point connection, or you can call into a Video Conferencing meeting and participate as one of the endpoints in that meeting.
Specifics
IP: 132.229.214.149
Protocol: H323
How to operate
The Cisco SX20 system consists out of a controller box, a movable camera and a table microphone pad. It is connected to the LG screen through its HDMI connector (The LG can also be used as a presentation screen without using the Video Conferencing unit, by selecting the PC input).
Start
Before one can start with any displaying, the LG screen needs to be switched on. This can be done by pressing the top row 'On' button on the desktop switch board. You will see that the 'On' button is blinking for a while, until the display is fully switched on.
Depending on a previous usage, one either sees on the display that the PC is not connected or one sees the startup screen from the Video Conferencing unit. In case the display says 'PC not connected' the desktop switch box has the PC button (on the third row) is highlighted. We want to use the Video Conferencing unit, so press the 'Video Conf' button to connect the Video Conferencing unit to the display.
