This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
institute_lorentz:gnulinux_workstations [2018/08/30 14:39] – [Compilers and libraries] lenocil | institute_lorentz:gnulinux_workstations [2020/09/14 06:48] – [GNU/Linux Workstations] lenocil | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== GNU/Linux Workstations ====== | ====== GNU/Linux Workstations ====== | ||
- | The standard Lorentz Institute workstation runs the GNU/Linux operating system [[https:// | + | The standard Lorentz Institute workstation runs the GNU/Linux operating system [[https:// |
are configured to host a variety of scientific and non-scientific software to maximize your productivity. | are configured to host a variety of scientific and non-scientific software to maximize your productivity. | ||
You are allowed to install and/or build packages locally (directories to which you have access), but for system-wide installations you must file a request through our [[https:// | You are allowed to install and/or build packages locally (directories to which you have access), but for system-wide installations you must file a request through our [[https:// | ||
Line 46: | Line 46: | ||
/ | / | ||
</ | </ | ||
- | In most cases, but not always, /data2 is configured as the mount point of a RAID[1|5] stack, meaning that data in it have a certain level of redundancy which can protect against disk failures. Note however, that storing all data on /data2 in RAID configuration will still not prevent data loss if all disks in the array `die', | + | In most cases, |
To check if any of your workstation' | To check if any of your workstation' |